So you have made the decision to rewire you house. You could save a lot of money by doing your own rewiring, and even if you have not picked up an electrical tool your entire life, you could still be able to pull it off given that you follow a step by step process.Before you start off, remember that your home electrical system is more than just a bunch of wires, it’s a complex and highly organized system designed to supply the power that you need, in the safest way possible.
Before you start on your DIY project of rewiring your home electrical wiring system, it is important to understand the electrical structure. The electrical system is consisted of a line from the ‘pole’, the main circuit breaker panel, and separate wiring circuits that goes to the rooms, to the outlets, and to the various hard-wired appliances. The main line descends off a pole, to the house where it then connects to the meter. The main breaker panels are installed inside the house. The wire circuits run through ceilings and walls to each room, and hard-wired appliances. After you understand this basic electrical wiring system in your house, then the next step is to acquire the required hand tools. You may have to purchase electric drills, and an all purpose tool to cut and strip wires. Before you embark on the task, is it required that you obtain a permit, without which you cannot undertake any electrical rewiring job. Then get an electrician to carry out an electrical system inspection, before you begin. After all these step are done, then you are at liberty to carry on with the DIY project.
First, make sure you measure and mark the box locations. The electrical codes may differ; therefore it’s important to figure out the minimum box size required by the National Electrical Code which differs depending on the area that you live. The next step is to drill holes in the framing. After the boxes have been nailed up, you can go ahead with drilling the holes, and pulling off the cables. Afterwards, tread the cable through the holes from one box to the next. You will need to cut and strip the wires, and finally fix in a paddle fan. If you can get your hands on a step by step rewiring manual, things will be a lot easier.
There are inherent risks involved in installing and replacing an electrical system. This is why it is necessary to carry an electrical system inspection before you embark upon the task. Consulting a local electrician is better than consulting a commercial electrician Castle Hill as their services are better suited as it is a house wiring system. The minimum number of outlets and distance between them are stipulated by the codes, but where you need your electrical appliances and therefore the placement of the outlets must be decided by you, and this decision must be made before hand as it difficult to change the system once it’s installed.
Even if you are not a pro, with a manual that explains the procedure step-by-step you may easily make replacing the electrical wiring system in your house a DIY project, and be successful at it.